When a cutting job is completed and the oxyfuel equipment is no longer needed, the first step in shutting down the oxyfuel cutting equipment is to _____.

a. close the fuel gas cylinder valve
b. back out the fuel gas and oxygen regulator adjusting screws
c. open the fuel gas torch valve
d. open the oxygen torch valve


a. close the fuel gas cylinder valve

Trades & Technology

You might also like to view...

Las abreviaciones estándar en documentos eléctricos normalmente se definen en el/la:

a. diagrama unifilar. b. leyenda. c. bloque de títulos. d. nota de revisión.

Trades & Technology

Technician A says to replace all original Grade 5 fasteners with Grade 8 when performing suspension repairs. Technician B says that a Grade 8 rated Huck fastener may be replaced with a Grade 8 nut and bolt. Who is right?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology

Clothes washer efficiency is rated with a(n) ____ energy factor, which considers the energy required to operate the washer, heat the water, and dry the clothes based on how much water is removed in the spin cycle.

A. estimated B. measured C. modified D. rated

Trades & Technology

An ellipse uses a consistent radius to be created.

Answer the following statement true (T) or false (F)

Trades & Technology