When turning to size predictably:

A) A trial cut is taken and a spring caliper is set to the size using a rule. This is sufficiently accurate for finishing most outside diameters.
B) A short skim cut is taken and measured. The cross slide feed collar is zeroed and the roughing cut depth is dialed. A trial cut is taken and the crossfeed screw backed off after noting the setting. The diameter is checked, the tool is returned to the start position and the dial reset to its former position. The cut is taken. This procedure is continued to finish size.
C) A short skim cut is taken and measured. The cross feed collar is zeroed, and the roughing cut is dialed. A trial cut is taken and checked and the cut is taken. This procedure is continued to finish size.
D) A trial cut is taken that looks like the approximate diameter or slightly over and it is checked with a micrometer. This procedure is continued to finish the part.


C

Trades & Technology

You might also like to view...

Define potable water and describe some of the inherent problems of surface-collected water.

What will be an ideal response?

Trades & Technology

What body motion should be used when adjusting a valve?

A. Pushing B. Pulling C. Left to right D. Right to left

Trades & Technology

Floor joists are horizontal structural members used to support the floor decking.

Answer the following statement true (T) or false (F)

Trades & Technology

The basic light-emitting diode is formed by joining gallium arsenide (GaAs) or ____________________ (GaP).

Fill in the blank(s) with the appropriate word(s).

Trades & Technology