Although 3D modeling can describe part and assembly configuration in accurate detail, many parts or features are rarely included in a model until very late in the process if included at all. List four parts or fea¬tures that fall into this category, and give reasons for omitting detail
What will be an ideal response?
Any standard hardware
You might also like to view...
The circular mil area of stranded wire is determined by finding the area of one of the strands and then ____ the number of strands.
a. adding b. subtracting c. multiplying by d. dividing by
Traffic on the eastbound approach of a signalized intersection is traveling at 35 mi/hr, with a density of 46 veh/mi/ln. The duration of the red signal indication for this approach is 30 sec. If the saturation flow is 1900 veh/h/ln with a density of 52 veh/mi/ln, and the jam density is 125 veh/mi/ln, determine the following: (i) The length of the queue at the end of the red phase (ii) The maximum queue length (iii) The time it takes for the queue to dissipate after the end of the red indication.
What will be an ideal response?
Which of the following systems will require disabling the high voltage (HV) system during service?
A) Tire rotation B) Air filter replacement C) Oil change D) Electric AC compressor replacement
Which of the following cannot be permanently programmed?
A) EEPROM B) DIMM C) EPROM D) Flash