The smallest dimensions are shown on the print ____ the object, with ____ the object.
A. closest to; progressively smaller dimensions outward from
B. closest to; progressively larger dimensions outward from
C. farthest from; progressively smaller dimensions above
D. farthest from; progressively larger dimensions above
E. none of the above
Answer: B
You might also like to view...
?Why is it important to have a drawing be accurate?
A. ?So that when a dimension is missing you can measure the drawing with a rule to get the missing dimension. B. ?So you can see missing parts easier. C. ?Engineers that have to approve the project when it is built can measure the part and measure the drawing to see that you built the part correctly. D. ?So that parts will fit together properly.
The focal point of a design is located
a. at the outside edge c. high in the middle portion b. at the top d. in the lower center
Analyze the frame in Figure P16.5 and draw the shear and moment curves for the members. Neglect axial deformation. EI is constant.
A technician attaches one lead of a digital voltmeter to the ground terminal of the TP sensor and other meter lead to battery negative terminal. The ignition is turned on, engine off and the meter displays 37.3 mV. Technician A says that this is the signal voltage and is a little low. Technician B says that the TP sensor ground circuit has excessive resistance. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician