_______________ is a moral obligation of people all over the world to preserve as much of our natural earth as we can so that future generations will be able to enjoy it, as well

Fill in the blank(s) with correct word


Sustainability

Trades & Technology

You might also like to view...

What is the formula for finding the total resistance in a series circuit?

What will be an ideal response?

Trades & Technology

Determine the number of steel studs needed for the tenant finish shown in Figure 16.16. The exterior walls are existing. The studs are spaced 16 inches on center. Add two studs for each door and each intersection.

What will be an ideal response?

Trades & Technology

Computer study of arch with a continuous floor girder. Repeat part (b) in problem P6.32 if a continuous girder with A = 102.5 in 2 and I = 40,087 in. 4 , as shown in Figure P6.33, is provided to support the floor system. For both the girder and the arch, determine all forces acting on the arch joints as well as the joint displacements. Discuss the results of your study of P6.32 and P6.33 with particular emphasis on the magnitude of the forces and displacements produced by the 48-kip load.



Computer study of a two-hinged arch. The objective is to establish the difference in response
of a parabolic arch to (1) uniformly distributed loads and (2) a single concentrated load.
(a) The arch in Figure P6.32 supports a roadway consisting of simply supported beams
connected to the arch by high-strength cables with area A = 2 in. 2 and E = 26,000 ksi. (Each
cable transmits a dead load from the beams of 36 kips to the arch.) Determine the reactions,
the axial force, shear, and moment at each joint of the arch, and the joint displacements. Plot
the deflected shape. Represent the arch by a series of straight segments between joints. The
arch has a constant cross section with
A = 24 in. 2 , I = 2654 in. 4 , and E = 29,000 ksi.
(b) Repeat the analysis of the arch if a single 48-kip vertical load acts downward at joint 18.
Again, determine all the forces acting at each joint of the arch, the joint displacements, etc.,
and compare results with those in (a). Briefly describe the difference in behavior.

Trades & Technology

A type of filter commonly Used for municipal water treatment is the

a. trickling filter b. diatomaceous-earth filter c. closed pressure filter d. open mixed-media filter e. membrane filter

Trades & Technology