List three items that should be included in detail drawings.

What will be an ideal response?


1. Multiple views, as necessary
2. Material(s) used to make the part
3. Dimensions
4. General notes and specific manufacturing information
5. Identification of the project name, the part, and the part number
6. Name or initials of who worked on or with the drawing
7. Any engineering changes and related information

Trades & Technology

You might also like to view...

?Why do some wire reels have covers?

A. ?To keep the wire from slipping off of the reel and tangling each time the wire feed stops. B. ?To protect them from dirt and dust. C. ?So it will be easier to rewind the wire after your test runs have been completed. D. ?It makes it easier to install new wire reels when needed.

Trades & Technology

Dead creatures are of no value to wildlife

Indicate whether the statement is true or false

Trades & Technology

Which of the following was part of the URAA?

a. Members were required to convert non tariff barriers to tariffs of TRQs. b. Members were required to reduce trade distorting subsidies 20% over 5 years. c. Export subsidies were required to be reduced. d. Sanitary and phytosanitary regulations were required to be science based. e. All of the above.

Trades & Technology

What is the cutoff frequency in Figure 12-3?

A) 796 Hz B) 637 Hz C) 637 kHz D) 7.96 kHz

Trades & Technology