If the seal was not properly aligned or there is excessive wear in some bearing or shaft, _____ wear tracks will be the indicator

A) parallel B) radial C) irregular D) narrow


C

Trades & Technology

You might also like to view...

Which of these building plans will exhibit the least air conditioning load?



A) (100' × 100')
B) (80' × 125')
C) (80' × 100')

Trades & Technology

Technician A says a fixed geometry turbocharger requires pressure relief because it operates over a wide rpm band. Technician B says a wastegate is commonly used to control the speed of the turbine in automobile engines. Who is correct?

A. Technician A B. Technician B C. Both technicians D. Neither technician

Trades & Technology

Refer to Exercise 4. Find a 99% lower confidence bound for the proportion of smokers who have tried to quit smoking in the past year.

What will be an ideal response?

Trades & Technology

Capacitive reactance is measured in ____.

A. ohms B. farads C. hertz D. watts

Trades & Technology