A backing weld is made after the weld on the front side of the weld joint has been made.
a. True
b. False
b. False
You might also like to view...
Water is to be cooled by passing through the tube in an insulated cross-flow heat exchanger, while air flows over the outside surface of the tube. The water enters the 4.0 cm-diameter pipe with a velocity of 15 m/s, a temperature of 150oC, and a quality of 0.10. The water exits as a liquid at 100oC. (This can be approximated as a saturated liquid at 100oC.) The air enters the heat exchanger at 15oC. (a) For a mass flow rate of the air of 5.0 kg/s, determine the air exit temperature. (b) Using your heat exchanger model to acquire the data, plot the exit temperature of the air as the air mass flow rate varies from 4.0 kg/s to 25 kg/s.
Consider State 1 to be the water inlet and State 2 to be the water outlet. Consider State 3 to be the air inlet and State 4 to be the air outlet. Given: T1 = 150oC; x1 = 0.10; D1 = 4.0 cm = 0.04 m; V1 = 15 m/s; T2 = 100oC (take x2 = 0) T3 = 15oC, m?air = 5.0 kg/s Assume: Q? = 0 (insulated). Also, given no other information regarding the heat exchanger, make the following common heat exchanger assumptions: W? = ?KE =?PE = 0 Also, assume the heat exchanger is a multiple-inlet, multiple-outlet, steady-state, steady-flow device. Treat the air as an ideal gas with constant specific heats: cp = 1.005 kJ/kg-K; ?hair = cp,air ?Tair What will be an ideal response?
The plants we use in our everyday lives are very similar to those found in the wild
Indicate whether the statement is true or false
In the term "source-to-sink movement" what is the source and what is the sink?
What will be an ideal response?
Which abbreviation describes the shift register used for serial-to-parallel conversion?
A) SISO B) PIPO C) PISO D) SIPO