__________ is the process of varying fluid flow by changing the settings on fluid flow controls such as valves, dampers, and blowers.
A. Adjusting
B. Balancing
C. Documenting
D. Testing
Answer: A
You might also like to view...
In Problem below, if the updated message is sent every 5 seconds, what is the upper limit on the number of messages initiated periodically if a table-driven routing protocol is to be used? Explain clearly.
A given ad hoc network consists of 100 nodes, and the mobility of the nodes is such that every one second, two existing radio connections are broken, while two new radio links are established. Assuming each node is connected to exactly four adjacent nodes, find the total number of communications links in the network.
Identify the correct order for the Lockout/Tagout procedure:
____ Shut down any auxiliary systems, such as lube oil and seal flush systems. ____ Close the pump suction and discharge so liquid does not enter the pump. ____ Lock and/or tag the valves and breaker for the motor or valves on the turbine ____ De-energize the driver by opening the breaker to the motor or blocking the inlet and exhaust steam valves on the turbine. ____ Flush/purge the pump to clear the pump of the chemical contained in the pump. ____ Drain the pump to the designated collection system.
Use the accompanying figure to compute angle C to the nearest hundredth of a degree. Angle A is 28o and angle B is 9o.
A. 16.70o B. 22.90o C. 27.71o D. 30.11o
Compared to throttle-body injection (TBI) systems, what are the advantages of port fuel injection systems?
What will be an ideal response?