A basic starter control circuit energizes the magnetic switch through the ignition switch and the:

a. solenoid.
b. neutral start switch.
c. starter over-running clutch.
d. regulator.


Ans: b. neutral start switch.

Trades & Technology

You might also like to view...

Orthogonal signal generation for two users.

The following worksheet specifies a pair of 10 sample orthogonal data signals sA sub "i" and sB sub "i" with amplitude specified in A2. TDMA signals are computed in C6:D15, FDMA in F6:G15 with frequencies defined in F2 and G2 in units of periods per n sub "x" (=10), and CDMA in I6:J15. The orthogonality condition is computed in L17. The signal energy is computed in Row 17
a. What is the formula in C8?
b. What is the formula in C17?
c. What is the formula in F8?
d. What is the formula in F17?
e. What is the formula in G8?
f. What is the formula in I8?
g. What is the formula in I17?
h. What is the formula in L17?

Trades & Technology

Individual freestanding partitions or groups of them secured together can be powered using a single flexible cord, provided that there are no more than _____.

a. to the general public b. to qualified persons only c. during daytime hours d. to a 600V service

Trades & Technology

The _____ is the distance from the end of the contact tip to where the wire electrode is melted off.? ?  

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Which of the following statements about the installation of grounding electrodes is not true?

A. A water pipe grounding electrode must be supplemented by at least one other grounding electrode. B. A concrete-encased grounding electrode must be at least 21?2 ft (750 mm) below the earth’s surface. C. A ground ring grounding electrode must encircle the building at a depth of 21?2 ft (750 mm) or more. D. A pipe-type grounding electrode must be driven 8 ft (2.5 m) vertically where practicable.

Trades & Technology