When changing a timing belt it is recommended that the ________ also be replaced
A) Air pump seal B) Front crankshaft seal
C) Air filter D) Air intake hoses
B
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. A starting relay is located away from the motor. 2. One disadvantage of the hot-wire relay is that it must be permitted to cool after each operation. 3. When testing the current relay, an ohmmeter can be used to check the continuity of the contacts. 4. The amount of voltage necessary to energize the coil of a potential relay is smaller than line voltage. 5. The solid-state relay can be used to replace almost any hot-wire relay.
To prevent the sequencer from controlling certain bits of an output word, a(n) ____________________ word is used.
Fill in the blank(s) with the appropriate word(s).
When performing arc welding on the rear of a truck chassis, where should the ground clamp be fixed?
A. On the front bumper B. On the battery ground post C. On the battery positive post D. As close to the weld area as possible
The NAHB Green program has ________ level(s) of green certification
A) 1 B) 2 C) 3 D) 4