Technician A says that it is necessary to keep flat tappets in order if the old cam and lifters are to be used again. Technician B says that used roller tappets should not be installed on a new camshaft. Who is right?
A. Technician A only
B. ?Technician B only
C. Both A and B
D. Neither A nor B
Answer: C
You might also like to view...
Most framing members in wood light-frame construction are 2-by members. What are the most commonly used sizes for: (i) studs, (ii) floor joists, and (iii) roof rafters?
What will be an ideal response?
A vehicle with the engine in the front can be ________
A) Front-wheel drive (FWD) B) Four-wheel drive (4WD) C) Rear-wheel drive (RWD) D) Any of the above
The primary and auxiliary drain lines should be
A) piped separately B) run level to assure an air seal C) connected inside the unit and then piped out together D) piped together to insure proper drainage
Technician A says that the multifunction switch operates the turn signals, windshield wiper and washer switch, and the headlight dimmer switch. Technician B says that the ignition switch is built into the lock cylinder. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician