The memory operation which presents data on the memory outputs after entering a new address is called
A) a write cycle. B) a read cycle. C) a refresh cycle. D) chip select.
B
You might also like to view...
What is the finish allowance shown at datum B?
Refer to Drawing Number 4190487 R0 and answer the following questions.
What is the purpose of a separation joint?
What will be an ideal response?
For an evaporator coil to transfer the maximum amount of heat, _____
a. the fin spacing should be very wide b. all of the surface area inside the tubes needs to be covered in flashing liquid c. the coil temperature should always be higher than the dew point of the air d. the subcooling of the entering refrigerant should be kept to a minimum
In regards to refrigerant flow through a fixed orifice tube:
A. It enters as a high pressure liquid B. It enters as a low pressure liquid C. It leaves as a low pressure gas D. It leaves as a high pressure liquid