If the large diameter of a 10-inch long part is 1.25", and the small diameter is 0.95" the taper ratio is:
A. 0.3
B. 0.95
C. 0.03
Answer: C
You might also like to view...
The following is a function of an expansion device: ____.
A. produce a reduction in the pressure on the liquid refrigerant B. regulate the flow of refrigerant into the evaporator C. lower the boiling point of the refrigerant far enough below the temperature of the load to get the needed heat transfer rate D. All of the above.
Convert 9.25 yd^3 to m^3
What will be an ideal response?
Technician A says that the crankshaft determines the stroke of an engine. Technician B says that the length of the connecting rod determines the stroke of an engine. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
The defrost cycle is normally terminated:
A) Based strictly on pressure to ensure safe operation for the compressor. B) Based strictly on temperature to ensure that all the frost has melted. C) Based strictly on defrost time to reduce the chance of sensor inaccuracy. D) Based on either temperature, pressure, or time.