Before an evaporative emission monitor will run, the fuel level must be where?

A) At least 75% full
B) Between 15% and 85%
C) Over 25%
D) The level in the tank is not needed to run the monitor.


A

Trades & Technology

You might also like to view...

Technician A says that engine torque is transmitted through the surface of the hollow driveshaft from the transmission to the rear differential in a RWD vehicle. Technician B says that a bent driveshaft on a RWD vehicle can cause a condition known as torque steer. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

What is the purpose of a chiller economizer?

A) To superheat the liquid refrigerant before it enters the chiller B) To subcool the liquid refrigerant before it enters the chiller C) To limit the compressor current draw D) To use outdoor air for cooling

Trades & Technology

What three general criteria are used to select zones for a building?

What will be an ideal response?

Trades & Technology

When setting up a nitrogen cylinder to pressurize a system for leak detection, the relief valve between the

nitrogen regulator and gauge manifold should be set no higher than _____. a. 75 psig b. 150 psig c. 200 psig d. 250 psig

Trades & Technology