Review drawing number 522973A0A and then answer the question.

a. How many holes are to be tapped?
b. What is the specification of the tap that is to be used?


a. 4
b. 5/16??-16 UNC

Trades & Technology

You might also like to view...

The amount of circuit voltage that is needed to force the circuit current through the resistance of the circuit conductors and load is called _______.

a. voltage b. amperage c. resistance d. voltage drop

Trades & Technology

Two technicians are discussing the front axle disconnect mechanism. Technician A says that the front axles are only disconnected if the vehicle is being towed. Technician B says that this unit is only used on

all-wheel-drive vehicles. Which technician is correct? A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B

Trades & Technology

The decimal equivalent of binary 10000110 is ________

A) 12610 B) 11010 C) 13410 D) 14410

Trades & Technology

What is one way of limiting current in-rush?

What will be an ideal response?

Trades & Technology