List three points that you should bear in mind when installing aftermarket body panels and parts.
What will be an ideal response?
Keep these points in mind when installing aftermarket body panels and parts:
| 1. | Remove the lower body panel from under the front bumper. |
| 2. | Place the new air dam under the front bumper and align the air dam with the wheel wells.Make sure that the front top lip of the air dam is located inside the front panel. |
| 3. | Clamp the corners of the air dam to the wheel well with vise grips. |
| 4. | Transfer the front body panel mounting holes with a scribe onto the air dam. |
| 5. | Use a scribe to transfer the mounting holes in the ends of the air dam to the wheel well. |
| 6. | Using the recommended size drill bit, drill the right amount of holes through the sheet metal and air dam. |
| 7. | Loosely bolt the air dam in position and check it for correct alignment. |
| 8. | Without overtightening them and causing part distortion, securely snug down all fasteners. |
You might also like to view...
A squeal is heard as the clutch pedal is depressed about one inch. This is probably caused by a ________.
A) Weak pressure plate B) Worn clutch disc C) Worn pilot bearing D) Defective or worn release (throwout) bearing
____________________ takes place at temperatures below 840 degrees F.
Fill in the blank(s) with the appropriate word(s).
The Clean Air Act is being discussed. Technician A says the Montreal Protocol is one of the results of the Clean Air Act. Technician B says it gave the EPA authority to control refrigerants in order to protect the environment. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
Consider laminar forced convection in a circular tube. Will the heat flux be higher near the inlet of the tube or near the exit? Why?
What will be an ideal response?