According to TROT what is considered an acceptable subcooling in most standard condensers

a. 10° b. 25° c. 30° d. 40°


a. 10°

Trades & Technology

You might also like to view...

Rafters are typically set 16 inches or 24 inches OC and are angled from the top plate of a wall to a(n) _____.

a. peak purlin b. top plate c. apex beam d. ridge board

Trades & Technology

Relations between the English colonists and the Powhatan were at first conciliatory, but remained tense, especially

A. when the English attempted to capture all the Indians from his tribe. B. as the Indians attempted to assimilate into the English culture. C. as the starving colonists took to raiding Indian food supplies. D. when the Indians joined tribes in the Powhatan Confederacy to unite against the English. E. when Powhatan allied with the Spanish.

Trades & Technology

The American Wire Gauge rates wires in size from smallest to largest as:

A) 4 mm to 40 mm. B) 000 to 50. C) 40 mm to 4 mm. D) 50 to 0000.

Trades & Technology

The starter motor on a V-6 engine is being tested for starter amperage draw. The initial surge current was about 210 amperes and about 160 amperes during cranking. Technician A says that the starter is defective and should be replaced because the current flow exceeds 200 amperes. Technician B says that this is normal current draw for a starter motor for a V-6 engine. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology