How should a typical timing gear be installed onto a shaft?
A. Press the gear on with a air-over-hydraulic press.
B. Cool the shaft as much as possible.
C. Heat the gear to the manufacturers specified temperature.
D. Heat the shaft and gear to manufacturers specified temperature.
Answer: C
You might also like to view...
If a pressure gauge is reading 15.2 bar, the psi equivalent would be _____.
a. 104.7 b. 150 c. 220.4 d. 223.44
Circuit breakers are grouped for identification according to _____.
a. line and load terminals b. given current ranges c. normal ambient temperatures d. solid-state circuitry
Which of the following is NOT one of the top three beef cattle-producing states?
a. Texas c. Nebraska b. Iowa d. Kansas
The design of a voltage divider begins with choosing the size of the bleeder resistor so that it will draw at least ____% of the load current.
a. 10 b. 20 c. 30 d. 40