What are the steps to check the power and ground circuits before removing and replacing a starter?
What will be an ideal response?
Start at one end of the circuit. With the ignition switch in the START position, check for power at the positive cable lug on the solenoid, where power enters the starter. Because this is the end of the circuit, when there is power here you will know that the positive side of the circuit is complete. If there is no power, work your way back through the system until you find power.
You might also like to view...
Holes can be drilled on a vertical milling machine by:
A) Using the sensitive quill feed B) Raising the knee of the machine C) Using the quill power feed D) All of the above
Technician A says that noncontinuous monitors include catalyst efficiency, EGR, EVAP, oxygen sensor monitors, oxygen sensor heater, secondary air injection (SAI), and thermostats. Technician B says that mode
$04 is used by service technicians to monitor the PCM test results of various systems. Which technician is correct? A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Today's landscape architects are using the new technologies of mechanized equipment and computers in conjunction with the design process
Indicate whether the statement is true or false
Sprinkler irrigation involves building a series of large and small ditches to transport water
Indicate whether the statement is true or false