Overheating can cause a terminal to discolor or the wiring insulation to melt. What should you consider when repairing the wire or the terminal?

A) It is recommended to replace the entire wire with another wire of the same of larger gauge. If the terminal is on a relay, sequencer, or fuse block, only the wire needs to be replaced. The component does not need to be replaced.
B) It is recommended to replace the entire wire with another wire of the same of larger gauge. If the terminal is on a relay, sequencer, or fuse block, the component should also be replaced in addition to the wire.
C) Replace the terminal end only. It is okay to cut off the end and repair the wire. If the terminal is on a relay, sequencer or fuse block, only the wire needs to be replaced. The component does not need to be replaced.
D) Replace the terminal end only. It is okay to cut off the end and repair the wire. If the terminal is on a relay, sequencer or fuse block, the component should also be replaced in addition to the wire.


B

Trades & Technology

You might also like to view...

Can a network be wireless, but not mobile? Explain your answer carefully.

What will be an ideal response?

Trades & Technology

Using the method of sections, determine the forces in the bars listed below the figure.

Trades & Technology

For the op amp circuit in Fig. 5.61, find the voltage gain v?/vs.

Trades & Technology

The voltage output of a zirconia oxygen sensor when the exhaust stream is lean (excess oxygen) is ________

A) Relatively high (close to 1 volt) B) About in the middle of the voltage range C) Relatively low (close to 0 volt) D) Either A or B, depending on atmospheric pressure

Trades & Technology