Which dimension should be given for the diameter of a spring on a drawing?
A. inside
B. outside
C. radial
D. both A and B
Answer: D
Trades & Technology
You might also like to view...
The type of form system that can be as wide as 50 feet are _____.
a. slip forms b. job-built wall forms c. gang forms d. insulating concrete forms
Trades & Technology
Plants grown for their leaves are called _____ plants
a. foliage c. decorative b. flowering d. floral
Trades & Technology
Those systems such as engine controls and antilock brakes that require data at a faster rate will communicate on the ____.
A. central gateway (CGW) module B. CAN bus C. CAN B bus D. CAN C bus
Trades & Technology
Canine distemper is caused by a
A. Virus B. Bacteria C. Fungus D. Rickettsia E. Protozoa
Trades & Technology