Rectangular coordinate dimensioning without dimension lines is also known as dimensioning with dimension lines.
Answer the following statement true (T) or false (F)
False
Trades & Technology
You might also like to view...
In Figure 14-1, the primary to secondary turns ratio is changed to 2.5:1 and the secondary current equals 100 mA. What is the reflected resistance seen by the primary?
A) 3 k? B) 1.2 k? C) 5 k? D) 2.5 k?
Trades & Technology
When should "soft foot" be checked?
A. before it gets bad. B. before alignment. C. during alignment. D. after alignment.
Trades & Technology
The inner hearth is the floor of the chimney.
Answer the following statement true (T) or false (F)
Trades & Technology
When an SCV used on a utility tractor?s hydraulic system is in the neutral position, the cylinder it is controlling
should _____. a. lock in a fixed position b. creep slowly c. extend d. retract
Trades & Technology