If the contacts on a starter become pitted, they should be:

A) Sanded and then coated with a fine layer of silver solder.
B) Replaced.
C) Jumped out to prevent nuisance trips.
D) Dressed with a file to remove the pitting.


B

Trades & Technology

You might also like to view...

The Cooks live in an old plantation house. The upkeep on the house is approximately $1,800.00 per year. The heating and cooling costs approximately $2,500.00 per year. The Cooks then build a new house that costs $185,000. They are able to pay 35 percent down and obtain a loan on the balance at 5.5 percent. They are able to arrange to pay off the principal in equal annual payments over 30 years, and the interest is paid annually on the remaining balance. The heating and cooling will be cut by 78 percent and the upkeep by 92 percent. How does the saving in upkeep, heating, and cooling compare to the interest paid the sixth year?

What will be an ideal response?

Trades & Technology

Answer the following statement(s) true (T) or false (F)

1. The metering facilities for electrical space-heating equipment as well as electric water heaters are standardized throughout the country. 2. The Code ® requires installation of a separate 20-ampere circuit for the laundry outlets. 3. The Code® requires the grounding of interior alternating current systems where the system can be grounded so that the maximum voltage to ground on the ungrounded conductors does not exceed 100 volts. 4. Proper bonding ensures a low impedance path to ground should a fault occur on any of the service-entrance conductors.

Trades & Technology

What is a buffer in feed?

What will be an ideal response?

Trades & Technology

Which of the following help the user define logic in a programming environment?

A) schematic editor B) waveform simulator C) compiler D) VHDL editor

Trades & Technology