In addition to load testing, what other kind of testing must a manufacturer conduct on liftplatform attachment points?
a. Non-destructive testing
b. Dimensional testing
c. Pull testing
d. Safety testing
a. Non-destructive testing
You might also like to view...
All the fourth-graders in a certain elementary school took a standardized test. A total of 85% of the students were found to be proficient in reading, 78% were found to be proficient in mathematics, and 65% were found to be proficient in both reading and mathematics. A student is chosen at random.
a. What is the probability that the student is proficient in mathematics but not in reading? b. What is the probability that the student is proficient in reading but not in mathematics? c. What is the probability that the student is proficient in neither reading nor mathematics?
A special washer-faced nut is shown in the accompanying figure. All dimensions are in inches. Determine the distance across flats if it is 55/64 x the distance across corners.
A. 1595/2048 in B. 1695/2048 in C. 1795/2048 in D. 1895/2048 in
In older zoning systems that use a master thermostat, the other zone thermostats _____
a. cannot control the system mode of operation b. can control the system mode of operation c. can control the mode but not the zone temperature d. cannot control the mode or the zone temperature
Consider a spherical shell of inner radius r1, outer radius r2, thermal conductivity k, and emissivity ?. The outer surface of the shell is subjected to radiation to surrounding surfaces at Tsurr, but the direction of heat transfer is not known. Express the radiation boundary condition on the outer surface of the shell.
What will be an ideal response?