Pneumatic tools use ________________ to power the tool.
A. electricity
B. gas
C. compressed air
D. chemicals
Answer: C
You might also like to view...
In the case of curved or irregular surfaces, the first step in creating an auxiliary view is to ____.
A. label the curve B. obtain a projection C. segment the edge D. draw a fold line
What are the five structural loads an installer should be aware of when determining whether a structure can be used to support a PV array and associated equipment?
What will be an ideal response?
This takes into consideration the combined effect of the feature tolerance and the geometric tolerance at MMC.
a. composite positional tolerance b. projected tolerance zone c. virtual condition d. combined geometric tolerance
In dicot seeds, a stemlike structure called the ____________________ grows upward and emerges as an arch-shaped structure with both ends still in the ground
Fill in the blank(s) with correct word