Match each New Dealer below with the federal agency or program with which he or she was closely identified.
A.
Robert Wagner
1.
Department of Labor
B.
Harry Hopkins
2.
Public Works Administration.
C.
Harold Ickes
3.
Works Progress Administration
D.
Frances Perkins
4.
National Labor Relations Act
A. A-1, B-2, C-3, D-4
B. A-4, B-3, C-2, D-1
C. A-3, B-1, C-4, D-2
D. A-4, B-3, C-1, D-2
E. A-2, B-4, C-1, D-3
Answer: B
You might also like to view...
When building walls _____, a line should be used as a guide for laying the units.
A. 3' or longer B. 5' or longer C. longer in length than 4' D. longer in length than 3'
When installing a tandem drive axle truck on a chassis dynamometer, which wheels must be wedged and chained?
A. front axle wheels B. forward drive axle only C. rear drive axle only D. both drive axles
Why is electricity distributed using extremely high voltages?
A) For safety because the insulation on the electrical distribution lines is not as effective at lower voltages. B) Higher voltages are easier to generate than lower voltages, so distributing them as a high voltage reduces equipment and saves money. C) To keep current as low as possible and reduce loss through the lines. D) High voltage electricity travels faster than lower voltage electricity and can get from one side of the country to the other in seconds.
The horizontal and vertical framing members of an aluminum window are screw-fastened together through screw splines, produced by the extrusion process. The following sketch shows a typical joinery detail of vertical and horizontal framing members. Using leader lines and labels, identify all screw splines in this sketch.
