Which of these tasks falls into the category of rough carpentry?
a. Applying exterior siding
b. Building and installing cabinets
c. Applying exterior trim
d. Framing a house
d
You might also like to view...
What is the power output of the turbine?
Steam at 1400 kPa and 350°C [state 1] enters a turbine through a pipe that is 8 cm in diameter, at a mass flow rate of 
The exhaust from the turbine is carried through a 25-cm-diameter pipe and is at 50 kPa and 100°C [state 2].
Which of the following marks on the tape measure is longer?
1/4”, 1/16”
Some holes, slots, and cutouts with odd geometries can be made with an operation called ____, in which a long toothed cutting tool is rapidly slid through the workpiece to form a hole or slot.
A. guiding B. broaching C. electric discharge machining D. lathing
Technician A says a temperature-controlled fan clutch is controlled by a spring that shrinks when it is heated and expands when it is cooled. Technician B says that electric fans found on many late model cars sometimes run after the engine is shut off. Who is correct?
A. Technician A B. Technician B C. Both technicians D. Neither technician