____ welds may be specified as performing a sealing function only, such as when fabricating tanks and other metal containers that must be leakproof.
A. Butt
B. Edge
C. Groove
D. Joined
Answer: C
You might also like to view...
Which of the following values is a typical of NOP of most 2-terminal EUIs?
A. 3,500 psi B. 5,000 psi C. 12,500 psi D. 25,500 psi
When replacing a drive axle shaft, be sure to ________
A) Use a pry bar or special tool to remove the inner joint B) Loosen the retaining nut with the wheels on the ground C) Torque the retaining nut to factory specifications D) All of the above
Electronically controlled valves, hydraulic pumps, and wet clutches are components found in a(n) _____.
A. Haldex clutch B. Torsen unit C. Quaife differential D. Control Trac II
Determine the heat transfer rate from an electronic chip whose surface temperature is 30ºC and has an exposed surface area of 4 cm^2. The temperature of surrounding air is 25ºC. The heat-transfer coefficient for this situation is h = 25 W/m^2·k . Express your answer in both SI and U.S. customary units. What is the R-factor (film resistance) for this situation?
What will be an ideal response?