Technician A says that the outer portion of the driveshaft can be used as a slide hammer to pop the inboard CV joint out of the transaxle. Technician B says that you should not hammer on the outer end of the outboard CV joint to get it out of the hub. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
B
You might also like to view...
The purpose of the defrost cycle in a heat pump is to _____.
a. warm the unit circuits for optimum electrical operation b. prevent ice buildup on the indoor coil c. prevent ice buildup on the outdoor coil d. remove frost buildup throughout the system ductwork
In steel studs up to 20-gauge thick, hole punches are used to make small holes up to approximately _____.
a. 1/2" b. 1-1/2" c. 2" d. 2-1/2"
Humans are dependent on the interconnectedness of life for survival
Indicate whether the statement is true or false
If frequency increases in Figure 13-1, the impedance ________ and the current ________
A) increases, decreases B) decreases, increases C) increases, increases D) decreases, decreases