Grounded windings can be detected by measuring the resistance with a multimeter between:
A) The start winding and common terminal. B) The run winding and common terminal.
C) The windings and the motor frame. D) The start winding and run winding.
C
You might also like to view...
You have been assigned to conduct a site assessment for a lake in Montana. There is a new biofuels plant operating and discharging into the stream that feeds the lake and agriculture around the lake for cattle and switchgrass. You observed high levels of algae floating on the surface of the lake, and the water was highly turbid. You also measured the DO at 1 meter to be 5 mg/L and at a depth of 20 meters the DO was 1.0 mg/L.
a. How would you describe the productivity level of the lake? Explain your reasoning. b. Similar lakes have had threatened Yellowstone Cutthroat Trout populations. But this lake does not. What changes would you suggest be made in managing the lake’s water quality prior to the reintroduction of trout to the lake? What will be an ideal response?
?Technician A says that if the camshaft is too tight after new cam bearings are installed, the bearing can be sanded with emery cloth. Technician B says that the front cam bearing is always installed flush with the front of the block. Who is right?
A. ?Technician A only B. ?Technician B only C. ?Both A and B D. ?Neither A nor B
Convert 305 cubic inches to liters
What will be an ideal response?
Dams, highways, and bridges would be classified as what type of project?
a. Residential b. Building construction c. Industrial d. Heavy construction