Referring to the following figure, the blower motor does not operate in High speed but operates correctly in Low or Med speeds. What could be the cause?
A. Defective resistor block
B. Shorted to ground circuit A77F
C. Defective blower switch
D. All of the above could cause this problem.
Answer: C
You might also like to view...
In which of the following applications is the use of a synthetic engine oil especially recommended?
A. exceeding the OEM service intervals B. extreme cold weather operation C. dynamometer operation D. stationary operation
Answer the following statement(s) true (T) or false (F)
Safety glasses are standard PPE that you should use when installing any fixture.
If a run of conduit is plumb, it is __________ to the floor.
a. parallel b. at a right angle c. 45 degrees d. positioned near
New tie rods are being installed. Technician A says to tighten the retaining nuts to specification and then loosen, if needed, to align the cotter pin hole. Technician B says to tighten farther to align the cotter key hole. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician