What are some of the things that may be required to correct situations that cause robots to crash?
What will be an ideal response?
This could require changing the position of a point in the program, putting a
pause in the timing of the program, adding an input to the robot system, replacing
a worn out/faulty sensor, tightening bolts in a fixture, removing things that do not
belong in the work envelop, and so on.
You might also like to view...
Fitting covers should only be applied on threaded pipe joints _____.
a. after the pipe insulation has been applied b. before the pipe insulation has been applied c. above freezing d. below 100°F (38°C)
Cables run along the sides of framing members must be installed at least __________ from the nearest edge of studs, joists, or rafters.
a. 3 inches b. 6 inches c. 1-1/4 inches d. None of the above
A dwelling unit must have at least____ small-appliance branch circuits.
A. one B. two C. three D. four
The marked measurement in the figure above indicates _____
a. 9-11/16 centimeters
b. 9-11/16 inches
c. 9-13/16 inches
d. 9-13/16 centimeters