A reamer tapers 0.130" along a 4.250" length as shown in the accompanying figure. Set up a proportion and determine the taper for A if the  length A is 3.025 inches . Express the answers rounded to three decimal places.

A. 0.925
B. 0.110
C. 0.092
D. 0.093


Answer: D

Trades & Technology

You might also like to view...

State the requirements for the service-entrance switch stipulated by the Code®.

What will be an ideal response?

Trades & Technology

How do you know that the water did not form from evaporation alone?

What will be an ideal response?

Trades & Technology

An electric current of 5 A passing through a resistor has a measured voltage of 6 V across the resistor. The resistor is cylindrical with a diameter of 2.5 cm and length of 15 cm. The resistor has a uniform temperature of 90°C, and the room air temperature is 20°C. Assuming that heat transfer by radiation is negligible, determine the heat transfer coefficient by convection.

What will be an ideal response?

Trades & Technology

Which of the following could likely be a "layer" of information in a GIS?

A) data on rainfall changes over time B) soil drainage classes C) land capability classes D) both B and C E) all of the above

Trades & Technology