The minimum depth for a control joint is _____.

a. 3/8"
b. 3/4"
c. 1"
d. 1-1/4"


Answer: C

Trades & Technology

You might also like to view...

? Identify and state the historical significance ofLucretia Mott.

What will be an ideal response?

Trades & Technology

¿Cuál de los siguientes artículos abarca los equipos intrínsecamente seguros?

a. NEC® Artículo 502 b. NEC® Artículo 503 c. NEC® Artículo 504 d. NEC® Artículo 501

Trades & Technology

Two technicians are discussing ABS wheel speed sensors. Technician A says that some ABS use a sensor located in the rear-axle pinion gear area. Technician B says that all ABS use a wheel speed sensor at each wheel. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

On a vernier transit level, the line of sight is perpendicular to the horizontal axis when the telescope level

bubble is centered and the vertical circle/arc is set at _____. a. 0 degrees b. 90 degrees c. 180 degrees d. 270 degrees

Trades & Technology