A "witness mark" is a ________

A) Type of fastener B) Identification mark
C) Type of tool D) Mark where two parts have rubbed or touched


D

Trades & Technology

You might also like to view...

La ubicación de la cama de cada paciente debe contar con el suministro eléctrico de _____ circuito(s) derivado(s).

a. uno b. dos c. tres d. seis

Trades & Technology

A PLC is used to control the sequence in an automatic drilling operation. A human operator loads and clamps a raw work part into a fixture on the drill press table and presses a start button to initiate the automatic cycle. The drill spindle turns on, feeds down into the part to a certain depth (the depth is determined by limit switch), and then retracts. The fixture then indexes to a second drilling position and the drill feed-and-retract is repeated. After the second drilling operation, the spindle turns off and the fixture moves back to the first position. The worker then unloads the finished part and loads another raw part. Let the input/output variables for this system operation be (X1, X2, C1, Y1, etc.). As a first step, construct the ladder logic diagram for the system and write

the low level language statements for the system using the PLC instruction. What will be an ideal response?

Trades & Technology

Wheel back spacing is also called ________

A) Offset B) Rear spacing C) Negative offset D) Positive offset

Trades & Technology

What measurement is 1/16 inch larger than 1/4 inch?

A. 0.3125 B. 0.328125 C. 0.34375 D. 0.3750

Trades & Technology