Which of the following is true of  axial spray transfers using high current settings?

A. Higher currents are needed with smaller diameter wires.
B. High current aids welding sheet metal because the high heat cuts through sheet metal.
C. High current settings may cause the weld to be difficult to control in out-of-position welds.
D. The need for higher current removes some restrictions on the process.


Answer: C

Trades & Technology

You might also like to view...

Why is the harvesting of timber not really a threat to nature?

What will be an ideal response?

Trades & Technology

Draw the envelopes for maximum shear and moment in a 24-ft-long simply supported beam produced by a live load that consists of both a uniformly distributed load of 0.4 kip/ft of variable length and a concentrated load of 10 kips (Figure P12.42). The 10-kip load can act at any point. Compute values of the envelope at the supports, quarter points, and midspan.

Trades & Technology

New brake shoes are being installed and they do not touch the anchor pin at the top. Technician A says the brake shoes may not be the correct size. Technician B says the parking brake cable may need to be loosened. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

What is the current draw of a circuit with a resistance of 6 ohms when 120 volts is applied to the circuit?

What will be an ideal response?

Trades & Technology