The inside edges of the pipe must be ________ to ensure complete joint penetration throughout the full weld length
A) offset B) in alignment C) purged D) none of the above
B
Trades & Technology
You might also like to view...
?How can metal be checked to see if it is safe to clean in a caustic cleaner?
What will be an ideal response?
Trades & Technology
Which measurement should be taken first?
A) smoke B) draft C) stack temperature D) oxygen
Trades & Technology
Which two pins are assigned for CAN-C bus access on a J1962 connector?
A. pins 2 and 10. B. pins 5 and 16. C. pins 3 and 11. D. pins 6 and 14.
Trades & Technology
Which one of the following engineering disciplines is most likely to be involved with the design of military aircraft and missiles?
a. Mechanical Engineering b. Civil Engineering c. Electrical Engineering d. Chemical Engineering e. Aerospace Engineering
Trades & Technology