You are testing an energized solenoid in a series circuit using a voltmeter and identify the following circuit conditions:
Voltage measured from solenoid positive terminal to chassis ground: 12.6 V-DC
Voltage measured from solenoid negative terminal to chassis ground: 4.0 V-DC
Voltage dropped across solenoid positive to negative terminals: 8.5 volts
Where is the problem in the circuit likely to be found?
A. On the positive side of the load
B. On the negative side of the load
C. The load (solenoid)
D. No circuit problem based on this data
Answer: B
You might also like to view...
?In a standard normal distribution, about ____ percent of values are between 2 and 3 standard deviations above or below the mean.
A. ?2.2 B. ?3.6 C. ?4.3 D. ?5.6
The amount of heat required to change 1 pound of a substance 1°F is called:
A) Latent heat. B) Sensible heat. C) Specific heat capacity. D) Total heat.
Technician A says that a low-restriction exhaust system could prevent a back pressure-type vacuum-controlled EGR valve from opening correctly. Technician B says restricted exhaust can cause the EGR valve position sensor to fail. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
After being removed from the oven, stainless steel electrodes should not be exposed to the atmosphere for
more than _____. a. two hours b. four hours c. eight hours d. twelve hours