The final process that structural steel members must undergo during fabrication involves smoothing rough edges or surfaces to ensure the proper flatness for bearing purposes or fit. This process is known as ____.
A. finishing
B. terminating
C. polishing
D. refining
Answer: A
Trades & Technology
You might also like to view...
What could be wrong if the A/C compressor clutch cycles on and off rapidly?
Defective A/C compressor clutch B) Low refrigerant charge C) Shorted compressor diode D) Defective A/C compressor
Trades & Technology
The first step in sketching an isometric drawing of a brick is to ____.
A. sketch a Y B. sketch the bottom edges C. mark off the width D. mark off the length
Trades & Technology
Determine the signal f(t) whose Fourier transform is shown in Fig. 18.38. (Hint: Use the duality property.)
 figure 1.png)
Trades & Technology
During welding preparations, what should be set up around the welding area?
a. Oxygen cylinders b. Cotton curtains c. Arc blowers d. Welding curtains
Trades & Technology