What type of drawing shows the intended assembly of mechanical parts?

A. schematic
B. three-dimensional
C. extracted view
D. exploded view


Answer: D

Trades & Technology

You might also like to view...

Find the volume of water, in cubic inches, that can be held in a semicircular-shaped tank with a diameter of 12”, two flat sides that are each 10”, and a height of 3”. All dimensions are inside dimensions. Give the answer to the nearest hundredth.

Trades & Technology

Light quality can alter the growth response of shoots in vitro. What type of light tends to promote shoot proliferation and elongation?

What will be an ideal response?

Trades & Technology

Which of the following is NOT an occupational division found in agriculture?

a. agribusiness and agricultural production b. agricultural mechanics c. horticulture d. environmental protection and preservation

Trades & Technology

The highest capacity CPLDs contain about ________ equivalent logic gates

A) 1,000 B) 10,000 C) 100,000 D) 100

Trades & Technology