If there is one sheet drawn for one part, it is referred to as a ____.
A. monodetail print
B. standard part print
C. assembly print
D. manufacturing print
E. none of the above
Answer: A
Trades & Technology
You might also like to view...
Which of the following statements is correct?
a. Electronic defrost controls use logic to determine the need for a defrost cycle. b. Mechanical defrost controls are significantly cheaper than electronic models. c. A defrost cycle starts as soon as the coil temperature is below the setpoint. d. Mechanical defrost controls base defrost cycles on time alone
Trades & Technology
Define superheat.
What will be an ideal response?
Trades & Technology
Is coarse sand or fine sand recommended for use in potting media?
What will be an ideal response?
Trades & Technology
LP gas has a heat content of __________ Btu/cu.ft.
A. 1000 B. 1050 C. 3200 D. 5000
Trades & Technology