When installing a built-up beam, the joints should be positioned _____.
a. directly over support columns
b. as close to the span midpoint as possible
c. midway between support columns
d. at eight-foot intervals
Answer: A
Trades & Technology
You might also like to view...
Any time an E7018 low-hydrogen-type electrode is to be used, the weave pattern, if used, must not be any larger than ____ the diameter of the electrode.
A. one-and-a-half times B. two times C. two-and-a-half times D. three times
Trades & Technology
What is meant by the term anointing? What are the possible reasons for this behavior?
What will be an ideal response?
Trades & Technology
Explain how alpacas and llamas are placed in kush
What will be an ideal response?
Trades & Technology
Troubleshooting Walk-In / Low Temp - Diagnosis: Inefficient compressor Use vacuum check to verify bad valves
Trades & Technology