For welding in the 1G-ROTATED, 2G, and 5G positions, the pipe axis can vary from the basic position by as
much as _____.
a. 5 degrees
b. 10 degrees
c. 15 degrees
d. 20 degrees
c
You might also like to view...
Technician A says when checking voltage drops, the negative meter lead is connected to ground and the positive lead is connected to the component being tested. Technician B says the voltmeter is connected across the load with the circuit activated when testing voltage drops. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
Which of the following is NOT required for compliance with OSHA safety regulations?
A) Daily air quality measurements B) Current MSDS information C) Injury related records D) Regular safety training
When is the igniter energized on an induced draft furnace that uses hot surface ignition?
A) At the same time the induced draft blower is energized B) After the draft switch closes to prove the draft C) At the same time the gas valve is energized D) On the initial call for heat
A car is traveling at 85 kilometers per hour. How many kilometers does the car cover in 6 hours?
A. 510 B. 515 C. 520 D. 525