An alternate technique for placing the cutting-plane lines is called the ________________. When using this method for identifying sections, arrowheads point toward each end of the cutting-plane line and the section identification letters are placed at the ends of the cutting plane line. The view title is placed above the removed section.
Fill in the blank(s) with the appropriate word(s).
reference arrow method
You might also like to view...
If the wooden handle on a tool is cracked, _____.
a. it may be safely used until it breaks b. it can be repaired with electrical tape c. tag the tool out of service and do not use it d. it can be used until the crack exceeds 1/4” (6 mm)
A dc, separately excited motor is driving a hoist. The motor has an armature resistance of 1.5 ?, and a field constant (K?) equals to 3.5 Vs. The terminals of the armature circuit are connected directly across a 240 V, dc source. The field circuit is connected to an ac/dc, full-wave, solid-state converter. The control circuit of the converter is designed to maintain the speed of the motor constant. At full load, when the field current is at its rated value, the motor speed is 600 rpm. One day while the motor was operating at full-load conditions, a failure in the dc source caused the armature voltage to change suddenly. The control circuit of the field converter acted rapidly to maintain the motor speed at 600 rpm. Due to the action of the control circuit, the field flux was reduced by
25%. What was the percentage change in the armature voltage? Indicate whether the change was a voltage increase or decrease. What will be an ideal response?
By mid-1941, Japan believed that it had no alternative to war with the United States because President Franklin Roosevelt
A. was committed to Britain and Holland retaining their colonial assets and economic power in the Dutch East Indies. B. had in 1941 imposed a freezing of assets and a cessation of all shipments and other critical raw materials in an effort to persuade Japan to withdraw from China. C. demanded Japan renew its trade with America. D. break its treaty of nonaggression with Germany. E. None of these choices are correct.
Manufacturer warranty repair can be performed at independent service shops
A) True B) False