Which of the following is not a type of assembly print used in industry?

A. detail assembly
B. design assembly
C. pictorial assembly
D. erection assembly
E. none of the above


Answer: E

Trades & Technology

You might also like to view...

The proportion between the length of a line on a map and the corresponding length on the Earth’s surface is called the______

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

The poinsettia forms the flower buds naturally in late June and early July

Indicate whether the statement is true or false

Trades & Technology

An engine management system that has adapted existing hydromechanical fueling devices for control by computer is known as:

A. hybrid B. semi-cybernetic C. partial authority D. retrofitted

Trades & Technology

If a dispute arises in the field between the owner/engineer's resident project representative and the contractor's superintendent, the parties should:

A. remain at the location on the project site where the issue was first mentioned, then adamantly debate the issue in public view and within earshot of everyone at the site to obtain their sympathy. B. move the discussion to a location in the field office, then listen to the dispute, protest, or claim. Then the parties should discuss the issues calmly and rationally, even in the face of serious disagreements. C. move to a location inside the field office and immediately take up a stance to defend your position by out-shouting the other party. D. refuse to discuss the matter at all, but insist that the other party "submit it in writing" before the issue can be discussed.

Trades & Technology