If a drawing has more than one auxiliary view, one of them will always be called a secondary auxiliary view.

Answer the following statement true (T) or false (F)


False

Trades & Technology

You might also like to view...

Using the conversion 2.54 centimeters equals 1 inch, how many centimeters does 4 inches equal?

a. 10.16 b. 21.8 c. 202.3 d. 101.6

Trades & Technology

Two technicians are discussing deceleration rates. Technician A says that a one "g" stop is a gentle slowing of the vehicle. Technician B says that a stopping rate of 8 ft/sec2 is a severe stop. Who is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

On a positive-logic pulse, the trailing edge is the ________

A) falling edge B) positive-going edge C) LOW-to-HIGH transition D) rising edge

Trades & Technology

Technician A says the compressor is the dividing line of the refrigeration system, low- to high-side. Technician B says the metering device is the dividing line of the refrigeration system, high- to low-side. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology