The rate of voltage decrease as the amperage increases within the working range is known as ____________________.

Fill in the blank(s) with the appropriate word(s).


slope

Trades & Technology

You might also like to view...

Be careful when desoldering a surface mount component, because too much heat or time will remove not only the lead and solder from the board, but the ____________________ as well.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

A contaminated or defective MAF sensor is indicated if ________

A) The VE is bad B) The fuel trim number follows the airflow C) The fuel trim numbers are within ± 2% D) The BARO reading is lower than normal

Trades & Technology

Back rakes should be ground on the tool:

A) When the toolholder is of the straight type without a built in back rake B) At the angle given in Table 1 for turning various metals C) At the same time the side rake is ground D) All of the above

Trades & Technology

The electron flow within an electrical circuit is known as ____.

A. voltage B. amperage C. resistance D. wattage

Trades & Technology