The subsequent problems deal with the figure and table belowFor a Type J (Iron-Constantan) thermocouple configuration (as shown above) with a 0°C reference (Tref):where Vemf is the voltage difference produced by the junction pair (Vemf = VA ? VB in the figure).Assume that nodes A and B are at the same temperature, unless indicated otherwise. Assume that the op amp is ideal.If the iron wire leads connected at A and B were switched (i.e., connect the lower iron wire to A instead of B and connect the upper iron wire to B

instead of A), the output Vout would?

A. reverse sign
B. oscillate wildly
C. become zero
D. not change
E. become infinite


Answer: A

Trades & Technology

You might also like to view...

An AP covers an area of 50,000 m2 . If an area of area of 10,000,000 m2 is to be covered by many APs. How many APs will be needed if deployed in a mesh topology?

What will be an ideal response?

Trades & Technology

A device used to put trunk duct or extended plenum sections together is called a drive clip.

Answer the following statement true (T) or false (F)

Trades & Technology

Many birds are curious creatures and are often attracted to common toxicological hazards including

A. Zinc associated with galvanized wire, screws, bolts (zinc-based compounds help prevent rust) B. U.S. pennies (those minted after 1982 contain 96% to 98% zinc) C. Lead (sources may include toys, paint, batteries, galvanized wire, and plumbing materials) D. All of the above E. A and C above

Trades & Technology

To be considered a complete warm up cycle, the engine must reach a temperature of ________

A) 40° F B) 40° to 150° F C) 160° F D) None of these

Trades & Technology