There are basically two concepts that you need to keep in mind when specifying dimensions in an engineering drawing:

a. size and location.
b. size and material.
c. size and tolerance.
d. part number and material.


a. size and location.

Trades & Technology

You might also like to view...

? Identify and state the historical significance of the Colored Farmers National Alliance.

What will be an ideal response?

Trades & Technology

A consumer has an annual consumption of 1200 MWh with a maximum demand of 2.4 MVA. The maximum demand charge is $30 per kVA per annum, and the energy charge per kWh is 4 cents.

Trades & Technology

An entire panel of a duct module should be replaced if the _____

a. damaged area extends to within 8 inches of the edge of the panel b. panel has a 1/2-inch-wide tear in the facing c. panel has a 1-inch-wide tear in the insulation d. panel is cracked or creased

Trades & Technology

What is the meaning of the notation (200A 5000V DISCONNECT SWITCH)?

What will be an ideal response?

Trades & Technology